Circutor CVMk2 Series Manuale Utente Scaricare il pdf (Pagina 29)

CVM

CONFIGURATION

4.1 MEASURING

Measurement, communication and expansion card parameters (if available) can be modied

from the conguration menu.

To access the conguration inside the MENU, select Setup and conrm with the set key.

The menu on the top of the screen will appear as seen in the following gure.

In the MEASURE menu, the list of voltage and current transformers can be accessed. To modify

the transformer conguration parameters, press the EDIT button (F4).

4. CONFIGURATION

Position the cursor in the rst line of parameters (primary voltage). Use the up-down arrow

buttons to move the cursor to the desired parameter. Press SET to enter the numeric value to

be modied. The cursor will be positioned over the rst digit, corresponding to the largest value.

Use the left/right arrow buttons to navigate from one digit to another and the up/down arrow

buttons to increase/decrease the value of the digit.

The analyzer does not store programming changes that are made until

programming is complete. These changes are conrmed by pressing SET and

after the ok button. If the system is reset before said programming is complete or

if the user exits the menu using the esc button, the conguration settings will not

be stored in memory. To access to the conguration menu, refer to Chapter 4.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 151 152

Nessun commento

Circutor CVMk2 Series Manuale Utente Pagina 29