Circutor computer PLUS-TF Series Manuale Utente Scaricare il pdf (Pagina 37)

7.3.1 General information about the Setup menu

 To edit a field, follow the procedure described in section 5.4.

 The screen displayed on Fig. 41 will be displayed at the end of the adjustment procedure on any setup

screen, after the final validation of the settings with OK, indicating the cos  in each phase and three-

phase, as well as the kvar entered in each of the L1, L2 and L3 phases in case it is started. The menu

bar shows the options to continue editing values when you press Edit. The unit will start-up when you

press Run . At the end of the setup process, when the values displayed on the screen seem logical,

both in terms of cos  values and capacitor steps that will be connected, press Run. Otherwise, press

Edit to return to the setup menu and check for any errors.

Fig.41.- Exit any setup screen

7.3.2 Entering the setup menu

 To enter the setup menu, open the main menu (Fig.42). Use the arrows to select the

folder and press OK . The list of options shown on Fig.43 will be displayed.

Fig. 42.- Main menu

Fig.43.- Setup menu

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 68 69

Nessun commento

Circutor computer PLUS-TF Series Manuale Utente Pagina 37