Circutor MDC-20 Manuale Utente Scaricare il pdf (Pagina 27)

MDC-20

User Manual Page 27 of 58

Fig.7-7 . – Configuration of counter / meters

Meters: It is possible to configure the following parameters for each of the eight meters:

• Description: Alphanumeric name to identify the meter on the unit screen.

• Unit: Alphanumeric type data to identify the meter units.

• Factor: Multiplier value of each pulse, (for example kWh/impulse ratio)

Flows: Checking the selector will activate the flow variable. If this selector is not activated, it

will not be possible to view the flow value of the corresponding controller input.

Fig.7-8 . – Configuration of flow meters

To configure the flow meters the following fields must be defined:

• Description: Alphanumeric type data which allows you to enter a brief description of the

flow for better identification.

• Unit: Alphanumeric type data which permits a brief description of the units where the

flow is shown to be entered.

• Factor: Multiplier value of each input impulse, (for example litres/impulse)

• Time (min): Time in minutes for calculating the flow value.

• Calculation window (s): Time window, in seconds, that the software uses to calculate

an estimate of the flow, taking into account the value of the unit 's meter.

Digital inputs: To configure digital inputs, a description must be defined for each of them.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 57 58

Nessun commento

Circutor MDC-20 Manuale Utente Pagina 27