Circutor DHB Series Manuale Utente Scaricare il pdf (Pagina 13)

The pressure of the button combination and holding

them down ca 3 seconds, causes the reset of alarm signaling. This

operation acts only when the support function is switched on.

The pressure of the button combination causes the era-

sing of the minimal value.

The pressure of the button combination causes the era-

sing of the maximal value.

The pressure and holding down the button ca 3 seconds cau-

ses the entry in the programming matrix. The programming matrix can

be protected by the safety code.

The pressure and holding down the button during 3 seconds

causes the entry in the menu monitoring meter parameters. One must

move through the monitoring menu by means of and

buttons. In this menu, all programmable meter parameters are only ava-

ilable for readout. In this mode, the menu Ser is not available. The exit

from the monitoring menu is carried out by means of the button.

In the monitoring menu, parameter symbols are displayed alternately

with their values.

The service algorithm of the meter is presented on the fig. 7.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 49 50

Nessun commento

Circutor DHB Series Manuale Utente Pagina 13